Have you visited the Tech Support KnowledgeBase?
Texas Instruments has gathered specific resources about our product groups into an easily searchable format.
Specific areas for DSP, Analog, and Logic parts give you the fastest access to technical answers.
more
MSP430: Use of the port pins P1.4 - P1.7 on the MSP430x11x(x)
Problem:
Why are the pins P1.4 - P1.7 on my MSP430F1121 not
functioning as expected?
Solution:
The TEST pin on the MSP430F1121 requires a pull-down resistor < 30Kohm
for normal operation, as mentioned in the MSP430x11x1 datasheet. When
the TEST pin is high, P1.4-P1.7 are in the JTAG mode. If the TEST pin
is left floating, noise on the TEST pin can potentially switch the pins
P1.4-P1.7 to JTAG mode.
Disclaimer
In the event that information received from the TI Semiconductor Technical Support KnowledgeBase conflicts with written documentation that was supplied by TI or originated from TI, then the information in the written documentation prevails and should be used.
Have you visited the Tech Support KnowledgeBase?
